- receiver Rx43d-1
- geared motor G252M660P (kkpmo)
- miro servo S18JST
- lipo 1s 500mAh
- micro SMD switch
- micro socket for charging and for trailer connection
- 45 LEDs – 0603 and few 0402
The building process was quite straightforward. Although the headlights were a bit of a challenge. Other elements, thanks to the large space on this truck, were easily assembled. The model was bought on aftermarket and was quite expensive for an older Herpa product. But I couldn’t resist buying and bringing this model to life.
mikro-servo S18JST, Rx43d-1, big 1s LiPo 
Servo in place 
Servo in place 
Servo connected to the suspension 
Work on the switch 
Work on the switch 
Work on the switch 
Switch in place 
Preparation of the headlamps 
Front side marker lamp LED 
Work on headlamps 
Work on headlamps 
Top special and marker lamps 
Top lamps glued to the cabin 
Preparation of the tail lights of the truck 
Preparation of the tail lights of the truck and trailer 
Preparation of the tail lights of the truck and trailer 
Preparation of the tail lights of the truck and trailer 
Tail lights glued into place 
Work on the rear part of the truck 
Work on the rear part of the truck 
Work on the rear part of the truck 
Work on the rear part of the truck 
Work on the rear part of the truck 
Wires prepared for connection to PCB 
PCB with all LEDs’ resistors 
Receiver connected 
Final location of the cell on the truck 
Work on the rear socket for the trailer 
Work on the rear socket for the trailer 
Work on the rear socket for the trailer 
The receiver status LED is mounted on the dashboard 
Front and marker lights 
Work on the trailer 
Trailer wires connected to the trailer PCB 
The trailer is ready 
Truck and trailer connection 
The model is ready 
The model is ready 
The model is ready 
The model is ready 
The model is ready 
Scania R420 “S.A.M. Logistic”